Milwaukee EC Meter EC60

The conductivity meter is waterproof and floatable. The electrode is made of stainless steel and therefore very durable with a very fast response time.

Calibration (basic setting) is very simple. Pour the enclosed liquid into a small glass. After reading the instructions, switch on the calibration, immerse the electrode in the liquid, wait until the display shows the correct value, done.

The EC 60 conductivity meter has a wide measuring range, from 0 to 3.999µS, the display is in 1µS/cm steps.

To measure, simply remove the protective cap and immerse the electrode in the liquid to be measured. Wait until the display is still. Temperature compensation is automatic. The electrode should be rinsed with distilled or demineralised water for long life and can then be stored dry.

To avoid incorrect measurements, a battery level check is shown in the display.

If you forget to switch off the device, it switches itself off after 8 minutes.

And if the electrode should really be defective, it can easily be replaced.

Scope of delivery:

• Sturdy storage box
• Conductivity meter
• Instructions in German and English
• Calibration fluid
• Warranty card
• Quality check

Technical data:

• Measuring range EC: 0.00 to 3.999µS
• Measuring range TDS: 0.00 to 1ppm
• Measuring range temperature: 0.0 to 60.0°C / 32.0 to 140.0°F
• Resolution EC: 1µS/cm
• Resolution TDS: 1ppm
• Resolution temperature: 0.1°C / 0.1°F
• Accuracy EC: 2% deviation on the full measuring range
• Accuracy TDS: 2% deviation on the full measuring range
• Accuracy temperature: ±0.5°C / ±1°F
• Calibration: automatic, 1 point (EC12.88)
• Temperature compensation: automatic
• Electrode: Mi59P (replaceable)
• Operating range: 0 to 50°C / 32 to 122°F; max. rel. humidity 100%.
• Battery type: 4 x 1.5V button cell LR44 (included)
• Battery life: approx. 100 operating hours
• Automatic switch-off: after 8 minutes when not in use
• Dimensions: length 20cm, diameter 3.8cm
• Weight: 100 g